High Country Tek eVc-2, Electronic Valve Controller User Manual
Page 5
Electronic Controller Solutions for the Global Fluid Power Industry
Dual Path epc-2 & evc-2 Graphical User Interface (GUI) Guide: Cont...
The ‘Miscellaneous Information’ page shows the module serial number as
well as all versions of the software and GUI being used. This information
may be asked for by HCT support personnel during any contact you require
for help and guidance e.t.c.
The other information shown on this page is the HCT mailing address and
also the direct E-mail to our customer support group.
There is also a live link ( if PC is connected to the Internet ) to the HCT
website where extra information as well as the latest literature and product
details can be found as required.
Clicking the ‘Back >>‘ button will take the user to the previous screen.
Click the following for these functions:
Technical:
This will open a PDF version of this manual that is installed with the
Graphical User Interface software so it is available as a reference at
all times.
Contact:
This opens the users E-mail program and enters the HCT address
and subject ready for the user to communicate and send whatever information required to HCT.
About:
Opens the ‘Miscellaneous Information’ page displayed below, giving important information on the module and versions
of software that may be needed during any conversations or E-mail with HCT technical or field support personnel.
Help:
This opens a PDF document on the evc-2 going into more details on the programming that the user can utilize to modify
this original application software program if required ( GUI will NOT reflect any user changes made )
HCT Part Number:
999-10075
PC to epc/evc-2 connections:
To use the set-up program described above, the user
must connect a communication cable between the epc/
evc-2 and the user PC. This is achieved by using an HCT
supplied RS232 cable that will allow direct connection
between a 15 way Serial Port ‘D’ connector on the PC and
a polarized 4 way tower WeatherPack connector.
In the event that the PC does NOT have a 15 way Serial
Port ‘D’ connector, a high quality, broad band USB to
RS232 adaptor must be used.
For best results, only use adaptors recommended, tested
and approved by HCT.
Please contact our customer service department to dis-
cuss your needs if required.
HCT Part Number:
108-00119
USB to RS232 Adaptor:
See page 8 for
connection details
5