VariZoom VZRC100 - Manual

Recording:
Press the red “R” button to start and stop recording.
Video Return:
“A” button allows you to see what is being recorded through the viewfinder.
Zoom:
Your VZ-R Series controller features a variable rocker so that you can go from the slowest crawl to the fastest
speed attainable by your lens. The more you press the rocker, the faster the lens will zoom.
If your controller causes the lens to zoom on its own, you may need to calibrate the zoom rocker. To do so, first connect the
controller to the lens normally. On the underside of the rocker you will see a small brass hex socket screw, and on the flat end of the
rocker you will see a hole with a slotted adjustment knob inside. Loosen the brass hex socket screw with a 5/64” hex key and turn the
slotted adjustment knob (using a flat tip screwdriver) from left to right until the lens stops zooming, then tighten the brass screw.
Warranty Warning!
Do not open your control device. If you need service, call and
we’ll be happy to set up a service return. All products have a 2-year parts and labor warranty.
Please save your receipt and feel free to send us your comments and suggestions. Thanks!
VZ-RC100 / VZRF100
Power:
The VZ-R Series controller does not require batteries or
external power. Just plug the cable into the lens servo jack, and it’s
ready to use.
Tripod / Jib Mount:
Your VZ-R Series controller has a
clamping system for attaching to your tripod handle, shoulder support
or crane/jib. (Extension cables are available in 10, 20, or 50 ft lengths).
Thank you for purchasing the VariZoom VZ-R Series remote variable-speed zoom
controller for professional video lenses. We think you’re going to like it a lot. Here are
some important guidelines for safe and effective operation…
-- please keep this document for your records & reference --
VariZoom Lens Controls: 888-826-3399 / 512-219-7722
or visit us at www.varizoom.com
Connection:
Plug the 8-pin cable connector into the lens servo
jack located under the lens grip handle (FIG. 1). Be sure to match the
pin connections carefully. When properly connected, the cable should
be firmly seated within the jack. Thread the connector sleeve onto the
jack and tighten by hand.
FIND THE SWITCH MARKED “ZOOM – S / M” AND MAKE
SURE IT IS SET TO “S” (1a) – THIS SWITCH TOGGLES THE LENS
BETWEEN SERVO and MANUAL MODES (YOU WANT IT SET TO
SERVO MODE)
WARNING: ABUSE OF THE 8-PIN CONNECTOR MAY
RESULT IN DAMAGE NOT COVERED BY THE WARRANTY.
TREAT THE CONNECTOR GENTLY WHEN CONNECTING AND
DISCONNECTING IT FROM THE LENS.
*****
FIG. 1
1a