VariZoom VZSPGF12 - Manual

Recording:
Press the button above the zoom rocker to activate the
record/pause function on the camera.
Video Return:
The recessed black button allows you to see what
has been recorded through the viewfinder.
Zoom:
Your VZ-PG-F12 controller features dual speed control. First, set
the speed control knob to the maximum desired zoom speed. This determines
the top speed limit of the zoom (for instance, you might wish to go no faster than
a slow crawl). The thumb rocker is pressure sensitive and allows you to
smoothly ramp up to that speed and back down again. In other words, the zoom
speed is completely variable from the thumb rocker, up to the maximum speed
dialed in at the control knob. The speed control knob prevents you from
accidentally going faster than intended. When the speed control knob is turned
all the way down (completely counter-clockwise relative to the top of the
controller), the zoom control feature is turned off. When turned completely
clockwise, it is set to the highest speed capability. Zoom command speed
depends on the position of the control knob and the depression of the rocker,
and the zoom rate will be as fast or slow as your lens servo allows.
*Calibration feature: Should the PG-F12 controller cause your lens to
zoom on its own (without depressing the controller rocker), you can easily
remedy this problem by adjusting a calibration dial inside the controller
(see picture at right “B”). Simply connect the controller to your lens with
the camera turned on, remove the lid of the controller, and adjust the
calibration dial until the lens no longer zooms on
its own.
Warranty Warning!
If you need service, send your controller to a Varizoom Service
Center only. All controllers have a 2-year parts and labor warranty. Please, save your receipt
and send us your comments and suggestions. Thanks!
OPERATING INSTRUCTIONS
VZ-PG-F12
Power:
The VZ-PG-F12 controller does not require
batteries or external power. Just plug the cable into the lens servo
jack, and it’s ready to use.
Tripod / Jib Mount:
Your VZ-PG-F12 controller
comes with a quick-release swivel clamp for attaching firmly to
your tripod handle, shoulder support or crane/jib. Extension
cables are available from VariZoom in 10’, 20’ or 50’ lengths.
Thank you for purchasing the VariZoom VZ-PG-F12 remote
variable-speed zoom controller for Fujinon 12-pin video lenses.
We think you’re going to like it a lot. Here are some important
guidelines for safe and effective operation…
-- please keep this document for your records & reference --
VariZoom Lens Controls - 888-826-3399 – 512-219-7722
visit us on the web at www.varizoom.com
Connection:
Insert the VZ-PG-F12 cable connector
into the lens servo jack located under the lens handle (FIG. 1).
Be sure to match the locator notches carefully. When properly
connected, the connector should be firmly seated in the jack.
The connector should snap into place when properly aligned.
SET THE SWITCH MARKED “ZOOM - S/M” TO “S” (1a).
THIS TOGGLES THE LENS BETWEEN Servo and Manual
MODES (YOU WANT IT SET TO Servo MODE)
*****
WARNING: ABUSE OF THE CONNECTOR MAY RESULT IN
DAMAGE NOT COVERED BY THE WARRANTY. TREAT
THE CONNECTOR GENTLY WHEN CONNECTING AND
DISCONNECTING IT FROM THE LENS.
*****
1a
FIG. 1
B