Agri-Fab 45-03201 - Manual (Page 7)

7
11. (Figure 8) Assemble the height adjustment handle
to the
inside of the bracket on the end of the height
adjustment tube. Use two 5/16" x 1" hex bolts (E), 5/16"
flat washers (K) and 5/16" nylock nuts (J).
Tighten.
12. (Figure 8) Assemble the grip (W) onto the height
adjustment handle.
13. (Figure 9) Assemble onto a 5/16" x 1-1/4" hex bolt
(D) in the order listed, a 5/16" flat washer (K), the pivot
bushing (S), the height adjustment strap and the spacer
bushing (T). Insert the bolt through the upper part of
the double hole in the end of the sweeper housing and
secure it with a 5/16" nylock nut (J).
Tighten.
If your tractor hitch has 10" to 13" ground clearance refer
to figure 6. If your tractor hitch has 8" to 10" ground
clearance refer to figure 7.
8. (Figure 6 or 7) Assemble the hitch brackets to the hitch
tubes using two 5/16" x 2" hex bolts (B) and 5/16" nylock
nuts (J). The bolts should straddle the front hitch tube
bolt.
Do not tighten yet.
9. At this time tighten the four bolts fastening the hitch
tubes to the sweeper housing. Next, tighten the two bolts
fastening the ends of the hitch tubes together. Finally,
tighten the two bolts fastening the hitch brackets to the
hitch tubes.
10. (Figure 6 or 7) Assemble the hitch pin (Y), two 3/4" hitch
spacers (U) and the 1/8" hair cotter pin (M) to the hitch
brackets.
6
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH BRACKET
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH PIN (Y)
5/16" NYLOCK NUT (J)
HEIGHT
ADJUSTMENT
HANDLE
GRIP (W)
5/16" FLAT WASHER (K)
5/16" x 1" HEX BOLT (E)
8
9
7
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH BRACKET
ENGLISH
PIVOT BUSHING (S)
5/16" NYLOCK NUT (J)
SPACER BUSHING (T)
5/16" FLAT WASHER (K)
5/16" x 1-1/4"
HEX BOLT (D)
HEIGHT ADJUSTMENT
STRAP