VariZoom VZCINEMAPRO-K2 - Manual (Page 11)

- 10 -
wheel clockwise will tilt the camera up, and pressing the joystick forward will tilt the
camera down. If it is changed to – turning the encoded wheel clockwise will tilt the
camera down, and pressing the joystick forward will tilt the camera up.
Direction- Out will change the direction in which the head sends the signal back to the
controller. This will change the axis positions on the main screen display as they relate to
zero. I.E. a pan maneuver from left to right will have decrease the angle if the output
direction is marked as+. Switching the output direction to – will result in the angle
number increasing when a pan maneuver is made from left to right.
5. Motor Enable/Disable
To enable or disable control of pan, tilt, zoom, or focus, or to place pan or tilt in neutral,
while in the main screen select the “ENL” option.
The cursor box then appears in the top right corner, and lets you select one of the four
axes. Move the cursor over which axis you wish to control.
Pressing “enter” will disable, or enable that axis from the controller. When disabled,
power will remain to this axis, so it will hold its position. It will just be disabled from
control.
While holding “Menu”, press the “enter” button. This will place the selected axis (this
only works for pan or tilt) in neutral. That axis not only will be disabled from the
controller, and will no longer be powered allowing you to move the axis by hand.
From this menu, you can also set each axis for live playback, or manual control (this only
applies when playing back a move which will be addressed in a later chapter)