VariZoom VZTP760 - Manual

VZ-TP760
Lightweight Travel Photo Tripod
Thanks for your purchase of the TP760. This unit is rugged, light,
and easy to use, but we have specific guidelines to ensure that you
get your value out of the TP760. Please read the instructions before
operating and note the following warnings:
• Whenever adjusting the ball head, grasp your camera
firmly to prevent it from flopping over when the ball joint is
loosened.
• Make sure the locking lever for the quick-release plate is
securely fastened to prevent unwanted wiggle or
accidental release of the plate from the head.
• Do not overload the tripod (7 lbs. max) and NEVER lean
on it.
• We don’t recommend transporting the tripod with the
camera attached, as the camera is more likely to get
damaged this way.
1) Attach the quick-release plate to your camera and
tighten the thumbscrew securely.
2) Make sure the large ball-joint knob is tightened, then
insert the plate (w/ camera attached) into the socket on
the ball head and tighten the locking lever securely *.
3) Extend the legs to the desired height and secure the leg
clamps so the legs don’t slide.
4) The sliding latch at the top of each leg allows you to
adjust the angle of the leg for a wider or narrower stance.
5) The telescoping center post allows you to fine tune the
height of your camera. When the desired height is
reached, tighten the thumbscrew to secure the center
post position.
Should the leg clamps become loose
over time, use the supplied socket
wrench to tighten them.
*