Chain inspection – OZ Lifting Products Premium Chain Hoist OM User Manual
Page 14
Use the following chart to determine when the hook must be replaced. Replacement of the hook
is necessary if any of the previous page problems are found or the maximum dimensions on the
charts that follow are reached.
Chain Inspection
Inspect chain before each use. Between regular inspections visually check on a daily basis the following:
• Clean chain before inspection using a non-caustic/non-acid solvent
• Lubrication of the chain may be necessary if it binds up or is noisy
• Chain feeds smoothly into and from the hoist and does not emit cracking noise when hoisting a load
• Visually examine link by link for any nicks, gouges, weld splatter, corrosion, or distorted links pay close
attention to chain’s contact points, which may show excessive wear.
• Test hoist with load and observe operation of chain over load sheaves.
pg.14
Size
Standard
K (mm)
Max K
(mm)
0.5 ton
28
30.5
1 ton
26
28.5
1.5 ton
32.5
35.5
2 ton
32
35
3 ton
37
40.5
5 ton
46
51
10 ton
50
58
20 ton
81
100
30 ton
81
100
Size
Standard
H (mm)
Min H
(mm)
Standard
T (mm)
Min T
(mm)
.5 ton
19.1
17.1
13
11.7
1 ton
25.7
23.1
16
14.4
1.5 ton
28.8
25.9
17
15.3
2 ton
34.3
30.9
21
18.9
3 ton
43.9
39.5
25
22.5
5 ton
52.5
47
32
28.8
10 ton
60.5
54.5
40
36
20 ton
88.5
79.5
60
54
30 ton
88.5
79.5
60
54
Hook throat opening
Hook lower profile
Chain wear