Bloom Manufacturing LS42K Series - Manual (Page 6)

Section 4 Winch Break In
• Winches, like any other kind of machinery, require a “break in” to perform well and
to maximize their life.
• Use extreme care when first spooling cable onto the winch. Do not run the winch at
high speeds when performing this operation.
• Make sure that the cable is unrolled in a line ( to prevent kinks ) and slowly inhaul
the winch to install the cable.
• Do not exceed one half rated load or one half rated line speed for the first thirty
minutes of operation. This will ensure that the gears have an opportunity to wear
in properly
CAUTION
in properly.
Section 5 Winch Installation
• You must make sure that your winch is securely mounted in order for it to function
properly and to ensure safe operation.
• The mount must be flat to ensure proper alignment between the gearbox side, the
drum, and the end housing.
• With a hydraulically driven winch, make sure the hydraulic system is clean and
that all components function properly, especially the relief valve.
CAUTION
Winch Series
LS30K, LS32K, LS40K & LS42K
Base Mount (steel)
Thickness
1”
8 UNC
8
HARDWARE
REQUIREMENTS
Capscrews (Hexhead)
Size
Thread
Grade (plated)
Torque / Tightening
1.50”
Torque / Tightening
(foot pounds)
682
NOTES:
- Tightening torque above is based on use of clean, dry threads.
- Reduced torque by 10% when oil is used as a lubricant.
- Reduced torque by 20% if new plated capscrews are used.
THINK S-A-F-E-T-Y FIRST Bloom Mfg Inc. 319-827-1139
PAGE 6 OF 8
q y p p
04/2009