Summers 2510 DT - Manual (Page 87)

CD1/8K/8K1850
SUMMERS MFG. CO., INC.
5/10/11
INSTALLATION AND OPERATION
INSTRUCTIONS FOR 8K1850
HUBODOMETER W/ HOUSING
FOR SUMMERS DIAMOND DISK AND 2510 DT
Attach HUB ODOMETER to gang nut as shown in
photos with 3/8” x 4-1/2” bolt, flat washers and lock nut.
To prevent loosening, rotate gang to insure that bracket is
on center and spot weld at locations shown.
Position Hubodometer on inside of rear center gang. DO
NOT LOCATE HUBODOMETER BENEATH
IMPLEMENT WING HINGE OR AT WIDEST POINT
OF MACHINE. Hub Odometer will be damaged if
installed in these locations.
The Hub Odometer is calibrated at 359 revolutions per
acre. Refer to chart below for conversion for your
implement.
MACHINE
CONVERSION
FACTOR
Diamond Disk Width
Multiply by ___ for Acres
Covered
18 ½’ 1.04
21 ½’ 1.22
24 ½’ 1.37
28’ 1.58
32 ½’ 1.82
38 ½’ 2.16
44 ½’ 2.49
47’ 2.63
2510 DT Width
18 ½’ 1.00
21 ½’ 1.17
24 ½’ 1.32
28’ 1.52
32 ½’ 1.75
38 ½’ 2.08
44 ½’ 2.39
47’ 2.53
SECTION 4 - PARTS
4-25