Steffy Wood Products Wall Diaper Shelf - Manual (Page 3)

7
(refer to sketch at right)
Attach the hang strip to the wall using fasteners
that are appropriate to your building construction.
Be sure the angled side is facing UP and the angle
is facing the wall. The hanging strip MUST be
attached to a wall stud. DO NOT HANG THIS
UNIT ON DRYWALL ONLY!!
After wall strip is securley in place, lift the cabinet
onto the strip.
WARNING: It is critical that the
hanging strip is fastened to the wall
correctly. The cabinet may fall off the
wall if installed incorrectly. We
recommend you consult a building
professional if you are unsure of the
correct fastener.
6
(refer to sketch at left)
Attach a hanging strip to the top and side panels using
4, 1-1/2" long screws. The angled side on the strip
must be facing towards the FRONT of the cabinet. Be
sure all screws are tight.
5
(refer to sketch at right)
Attach the remaining side panel using six
connecting bolts and hex key. Be sure the
top, shelf, bottom and back panels are in
the slots in the side panel.
CHECK ALL BOLTS AND SCREWS
PERIODICALLY TO MAKE SURE
THEY ARE TIGHT!!
8
Slide the dividers into the slots in the
top panel and shelf. Be sure the
rounded edge is facing front.
SIDE PANEL
CONNECTING BOLT
HANGING STRIP
1-1/2" LONG SCREW
DIVIDER
Angle on strip towards wall