Steffy Wood Products Wall Locker - Manual (Page 2)

WARNING: It is critical that the hanging strip
is fastened to the wall correctly. The cabinet
may fall off the wall if installed incorrectly. We
recommend you consult a building professional
if you are unsure of the correct fastener.
4
Attach the right side using 6 connecting
bolts. Be sure the top, shelf, bottom
and back panels are in the slots in the
side panel. Go back and make sure all
bolts are tight in both side panels.
5
Attach the hanging strip (with holes) to the top and side panels
using 4, 1-1/4" long screws. The angled side on the strip must be
facing towards the FRONT of the cabinet. Be sure all screws are
tight.
Angled side DOWN
and facing FRONT
7
Attach the 5 coat hooks onto the bottom panel.
Place a post through each hole and attach each
hook as shown. Be sure all screws are tight.
6
Attach the hang strip to the wall using fasteners that are
appropriate for your building construction. Be sure the
angled side is facing UP and the angle is facing the wall. The
hanging strip MUST be attached to a wall stud. DO NOT
HANG THIS UNIT ON DRYWALL ONLY!!
After wall strip is securely in place, lift the cabinet onto the
strip.
CHECK ALL SCREWS PERIODICALLY TO MAKE SURE THEY
ARE TIGHT!!
Angle On Strip Towards Wall
RIGHT SIDE
HANGING STRIP
CEILING HOOK
1/2" LONG POST
1/2" FLAT HEAD SCREW