Warning – Steffy Wood Products Dress Up Storage User Manual
Page 2
TOP STRIP
LOWER STRIP
MIRROR
1-1/2" LONG SCREW
SIDE PANEL
SIDE PANEL
BOTTOM PANEL
TOP PANEL
4
Stand the unit upright. Attach the ceiling hooks
to the bottom of the top using the posts and flat
head screws as shown in sketch at right.
3
Attach the top and lower strips to the side
panels by inserting the plastic connectors in the
strips into the connecting screws on the side
panel. Using the supplied screwdriver, turn the
screw located in the plastic connector clockwise
until tight. Insert the 1-1/2" long wood screws
into the holes below the top and lower strips.
Tighten using the supplied screwdriver.
Mount the mirror to a side panel. Remove the
protective strips from the tape on the back side
of the mirror and locate in the desired position.
Press firmly around mirror after it is in place.
2
Refer to the sketch at right. Attach the side
panels to the top and bottom panels using
the hex key and connector bolts.
Be sure the bottom panel is attached in the
slot that is CLOSER to the edge of the side
panel.
CHECK ALL BOLTS AND SCREWS
PERIODICALLY TO MAKE SURE
THEY ARE TIGHT!
Slot closer to the edge of side panel
1/2" FLAT HEAD SCREW
WARNING !!
Serious or fatal crushing injuries can occur from
furniture tip-over. To help prevent tip-over:
Place heaviest items on bottom of cabinet.
Never allow children to climb or hang on doors or shelves.
Use of tip-over restraints may only reduce, but not
eliminate, the risk of tip-over.
5
Furniture tipping restraint hardware is included in with
the hardware package for this unit. Follow the
installation instructions printed on the restraint
hardware bag.
1-1/2" LONG SCREW
CEILING HOOK
INSERT 1/2" POSTS THROUGH
HOLES IN TOP