AquaStar ChemStar On-line Chlorinator - Manual

info @ aquastarpoolproducts.com www.aquastarpoolproducts.com
Your ChemStar ™ chlorinator is the most efficient and trouble-free automatic chlorinator you can buy, but it can
also be dangerous to you and your equipment. Please follow instructions exactly and heed all cautions.
• For permanent installation in return line on pressure side of pump,
downstream of all equipment, in new or existing pools or spas
• Completely enclosed system – no escaping gases so no special
venting required
• Standard with 2" slip PVC fittings and adapters for 11/2"
• 50 PSI maximum operating pressure
• Includes an external, fine, no-clog control valve that lets you adjust
the feed rate to meet specific pool or spa needs
• All parts are replaceable.
• Top-load large or small Trichlor or Bromine slow-dissolving tablets
enable an effective, trouble-free way to sanitize your pool or spa
• When used with time, chlorinator is designed to automatically lower
the water level so tablets are not soaking during off period of pump.
This allows more efficient use of tablets.
• No equipment damage because sanitizer is fed directly to pool or spa.
• To prevent over-chlorination during use, completely close the control
valve and the built-in check valve will stop chemicals from being fed
into pool or spa.
CH100 CHlorine/Bromine inline CHlorinator
FEATURES:
It is important to read all information BeFore proceeding with the installation. The information will guide you in installing your chlorinator
properly and help you avoid problems due to improper installation.
Never install the chlorinator into copper plumbing, as pipe damage will occur. (See Equipment Safety CAUTION sheet enclosed).
note: If heaters are used, a fireman’s switch or equivalent must be installed to prevent possible damage and improper operation of check valve and
other equipment subject to heat damage.
READ AND FOLLOW ALL INSTRUCTIONS
iF your pool or spa Has Copper plumBing . . . stop!!
WhERE TO INSTALL YOUR ChLORINATOR
The CH100 chlorinator is designed for permanent installation in the return line of your new pool or spa and must always be installed after the heater,
pool cleaner, valves, etc. If your pool does not have a heater, then it must be installed after the filter or any other piece of equipment.
Damage to the heater and other equipment could result if highly chlorinated water flows through it. Your chlorinator may be
installed in existing PVC plumbing but will require a union and/or other fittings. The chlorinator comes complete for installation
with 2" or 11/2" PVC plumbing. Choose a site in the return line where chlorinator can be installed in a vertical position. Always install as far from any
metal equipment as practical since fumes, etc. can corrode them.
INSTALLATION INSTRUCTIONS
MAkE SURE ALL PUMPS AND TIMER SWITChES ARE IN ThE oFF POSITION.