Hot Max Torches 100MC - Manual (Page 3)

Assembly Instructions
KDAR Company 2
Step 1
After removing all components out of the box,
locate the welded base frame (Item 1), two pneu-
matic tires (Item 18) , steel axle (Item 17), and
two cotter pins (Item 9). Note: The axle is often
shipped inside the welded base frame. Slide the
axle through the hole in the bottom of the welded
frame (sometimes paint makes this whole smaller
so you might need to use a hammer to get it in).
Slide the wheels over the axle on either side (hubs
in) of the base frame . Slide the cotter pins
through the small hole in the axle to secure the
wheels to the axle.
Step 2
Locate the two handle uprights (Item2), molded
handle (Item 3), and chrome bolts for the handle
(Item 10). Insert the chrome bolt (Item 10)
through the handle upright (Item 2) and into the
molded handle (Item 3) and hand tighten this bolt.
Bolt the opposite the handle upright to the handle
as well. Insert both handle uprights (Item 2) into
the welded base frame until the bolt holes line up.
Insert a 6 x 38 mm bolt from the front through
both the base frame and the handle uprights.
Sometime excess paint makes the bolts hard to
get in so use a wrench to thread them into the
hole. Place a 6 mm nut (Item 16) on the bolt and
hand tighten. Repeat the with another 6 x 38 mm
bolt and nut on the other side.
Note: It’s easy to not notice that there are two siz-
es of 6 mm bolts: 6 x 38 mm and 6 x 34 mm.
There are two 38 mm bolts (Item 14) and three
34 mm bolts (Item 15). If you place a bolt in a
location and it doesn’t seem long enough, double
check that you have the correct bolt.