Kenwood RC-D710 - Manual (Page 9)

3
CONNECTION TO PC
Use a PG-5G (option) cable when connecting the RC-D710 to a computer D-SUB
terminal.
Panel jack
RC-D710
TM-V71
Modular plug cable
Installing the Line Filter
Install the line filter approximately 3 cm from the
connector.
Approx. 3 cm
Line filter
To PC 9-pin
D-SUB terminal
COM terminal pin
NC
NC
CTS
TXD
RTS
GND
RXD
NC
PG-5G (option)
PG-5G pin configuration (cross connection)
CONNECTION TO TM-V71
Connect the RC-D710 to the TM-V71 using the supplied cable.
Line filter Panel jack