Siemens TE503209RW - Manual (Page 18)

14
en
2� Clean the individual parts with a deter-
gent solution and a soft brush� If neces-
sary, soak in a warm detergent solution�
3� Rinse all parts with clear water and dry
them�
4� Reassemble all the parts and replace
fully in the appliance�
A Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed�
Cleaning the brewing unit
Clean the brewing unit regularly�
To pre-clean the brewing unit automatically:
1� Select
e
by turning the rotary knob (14)�
2� Place an empty glass under outlet (7)�
3� Press the start button (10)�
The appliance rinses�
In addition to the automatic cleaning
programme, the brewing unit (5a) should be
removed regularly for cleaning� (See figure
E at the start of the operating instructions�)
1� Switch the appliance off at the power
on/off switch O / I (9)� No buttons are lit�
2� Open the door (5b) to the brewing unit�
3� Slide the red lock (5e) on the brewing
unit (5a) completely to the left�
4� Press the eject lever (5d) down fully�
The brewing unit is released�
5� Grasp the brewing unit (5a) by the
recessed grips and remove carefully�
6� Remove the cover (5f) of the brewing
unit and rinse the brewing unit (5a)
thoroughly under running water�
7� Thoroughly clean the brewing unit sieve
under the running water�
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher�
8� Wipe out the inside of the appliance
thoroughly with a damp cloth and
remove any coffee residues�
9� Allow the brewing unit (5a) and the
inside of the appliance to dry�
10� Replace the cover (5f) on the brewing
unit and reinsert the brewing unit (5a)
fully into the appliance�
11� Press the eject lever (5d) up fully�
12� Slide the red lock (5e) fully to the right
and close the door (5b)�