ASKO T793 - Manual (Page 17)

Cleaning the lint filter
The lint filter must be cleaned after each load.
If you have very hard water, this can cause
limescale deposits in the lint filter. Check for
any limescale deposits when cleaning the lint
filter and, if necessary, wash the filter by hand.
Additionally, the filter should be cleaned with
hot water, detergent, and a soft brush quarter-
ly.
1. Grasp the filter handle and pull it toward
you.
2. Pull the filter out of its holder.
3. Open the filter and remove the lint from all
sides of it by hand. Use a soft, dry cloth to
remove any deposits.
4. Replace the filter in its holder.
Note!
If you have hard water, the filter should be
washed with water to remove any limescale
deposits. Use a sponge and a little dishwash-
ing detergent if necessary. Dry the filter care-
fully with a towel. If you cannot remove the
limescale, you can buy a new filter from the
retailer where you bought the tumble dryer.
Cleaning the outside of the machine
Clean the outside of the machine and the
program panel with a mild cleaner. Do not use
solvents, as these can damage the machine.
Do not hose down or spray the machine with
water.
Note!
Do not allow dust to accumulate around the
machine. Keep the area around the tumble
dryer clean and cool; dust, heat, and moisture
prolong drying times.
17 Customer Care Center
1-800-898-1879
www.askousa.com
Care and maintenance instructions