Important information – Siemens LC457CA60 User Manual

Page 8

Advertising
background image

8

Important information

Additional information concerning gas
cookers:

When installing gas hotplates, comply

with the relevant national statutory
regulations (e.g. in Germany: Technische
Regeln Gasinstallation TRGI).

Always comply with the currently valid

regulations and installation instructions
supplied by the gas appliance
manufacturer.

Only one side of the extractor hood

may be installed next to a high-sided unit
or high wall. Gap at least 50 mm.

Minimum distance on gas hotplates

between the upper edge of the trivet
and lower edge of the extractor
hood:

650 mm, Fig. 1.

Recommendation:

700 mm.

Old appliances are not worthless

rubbish. Valuable raw materials can be
reclaimed by recycling old appliances.
Before disposing of your old appliance,
render it unusable.

You received your new appliance in a

protective shipping carton. All packaging
materials are environmentally friendly and
recyclable. Please contribute to a better
environment by disposing of packaging
materials in an environmentally-friendly
manner.

Please ask your dealer or inquire at your
local authority about current means of
disposal.

The extractor hood can be used in

exhaust air or circulating air mode.

The applicable regulations of the power

supply company and compliance of local
and national building regulations must be
observed when installing air extractors
(overhead and table top downdraught) in
permanent dwellings.

Always mount the extractor hood over

the centre of the hob.

Minimum distance between electric

hob and bottom edge of extractor hood:
550 mm, Fig. 1.
Recommendation:

700 mm.

The extractor hood must not be

installed over a solid fuel cooker – a
potential fire hazard (e.g. flying sparks) –
unless the cooker features a closed,
non-removable cover
and all national
regulations are observed.

The smaller the gap between the

extractor hood and hotplates, the greater
the likelihood that droplets will form on the
underside of the extractor hood.

Before reading these instructions, please fold
out the pages at the back with the illustrations.

This appliance is

labelled in accordance with
European Directive
2002/96/EG concerning
used electrical and
electronic appliances
(waste electrical and
electronic equipment –
WEEE). The guideline
determines the framework for the return
and recycling of used appliances as
applicable throughout the EU.

Advertising