Mounting the irx-dm – AMX Wall Mount Decor IR Sensor IRX-DM+ User Manual
Page 2
AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
042-004-2749 11/04 ©2004
AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-0458-10
REV: B
Mounting the IRX-DM+
1.
For wall or podium mounting (FIG. 5), AMX recommends mounting the
IRX-DM+ in a standard 1-gang wallbox with a minimum internal clear-
ance of 1 3/4" (W) x 2 5/8" (H) x 1 5/8" (D).
2.
Gently remove the bezel from the wallplate.
3.
Place the panel in the wallbox and align the screw holes with the
mounting holes on the panel.
4.
Turn the unit over and locate the Phoenix connector.
5.
Fasten the panel to the wallbox using the screws supplied with the panel.
6.
Snap the wallplate back on the bezel.
FIG. 5
IRX-DM+ Mounting Dimensions
wall plate
bezel