Environmental protection, Operating modes, Exhaust air mode – Siemens LD97AA670 User Manual

Page 13: Note, Air recirculation, Getting to know the appliance, Control panel

Advertising
background image

13

Environmental protection

Unpack the appliance and dispose of the packaging in an

environmentally-responsible manner.

Environmental protection

Operating modes

This appliance can be used in exhaust-air mode or circulating-
air mode.

Exhaust air mode

Note: The exhaust air must not be conveyed into a functioning

smoke or exhaust gas flue or into a shaft which is used to

ventilate installation rooms which contain heating appliances.

Before conveying the exhaust air into a non-functioning
smoke or exhaust gas flue, obtain the consent of the heating

engineer responsible.

If the exhaust air is conveyed through the outer wall, a

telescopic wall box should be used.

Air recirculation

Note: To bind odours in air recirculation mode, you must install

an activated carbon filter. The different options for operating the
appliance in air recirculation mode can be found in the
brochure. Alternatively, ask your dealer. The required

accessories are available from specialist retailers, from
customer service or from the Online Shop.

Getting to know the appliance

Here, you can get to know your appliance and receive

information about the accessories.

Control panel

This appliance is labelled in accordance with the
European Directive 2012/19/EU concerning used

electrical and electronic appliances (WEEE –
waste electrical and electronic equipment). The
guideline determines the framework for the return

and recycling of used appliances as applicable.

The air which is drawn in is cleaned by the

grease filters and conveyed to the exterior by a
pipe system.

The air which is drawn in is cleaned by the
grease filters and an activated carbon filter,
and is conveyed back into the kitchen.

1

Control panel

2

Light

3

Filter cover







Explanation
1

Retract/extend the appliance, switch the fan on and off

2

Switch on lighting

3

Turn the fan down

4

Display panel

5

Switch fan setting up

6

Intensive setting

7

Fan run-on time















Advertising