Night Guard Home Surveillance System PROFESSIONAL VEHICLE SECURITY SYSTEM RF-320 - Manual (Page 3)

3
PASSIVE DOOR LOCKING:
The vehicle doors will automatically lock after passive arming cycle has been completed.
ACTIVE DISARMING – UNLOCK & DISARM:
1. Press the button on the transmitter.
2. The siren will chirp twice and parking lights will flash twice to indicate that the security
system is now disarmed. The vehicle doors will unlock and disarm when interfaced with the
security system.
TAMPER DISARMING: If the alarm is triggered; upon disarm the system, the siren will chirp 4
times and parking lights will flash 3 times.
TWO STEP DOOR UNLOCK: This feature will independently unlock the driver’s door only when
disarming the security system. Pushing the
button on the transmitter a second time within 3
seconds will unlock the entire vehicle.
AUTOMATIC RE-ARM : If this feature is selected, the security system will automatically re-arm
itself 60 seconds after disarming with remote transmitter. Automatic rearm will cancel if any door
is opened before the 60 seconds timer has elapsed.
DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch The alarm will stop sounding and
enter the disarm mode. You can now start and operate the vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in
valet mode, all alarm functions are bypassed, however, the remote panic feature and remote
door locks will remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds or until the LED turns on. The LED will remain on
as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'ON'.
2. Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is
exiting the valet mode.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1. Press and hold the button on the transmitter for 3 seconds. The alarm will immediately
sound.
2. To stop the alarm, press and hold the or button on the transmitter, the panic mode
will be turned off immediately.
3. If the button is not pressed, the alarm will automatically stop after 30 seconds.