Alpine IVA-D100 - Manual (Page 50)

46
-EN
01GB06IVA100.fm
ALPINE IVA-D100 68-05946Z49-A (EN)
Adjusting the DVD Level
The volume (signal level) for Dolby Digital, Dolby PL II, DTS and
PCM modes can be set.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if the Decode mode is switched.
1
Check that Defeat mode is off.
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [ ] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [ ] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [ ] of DVD LEVEL.
The DVD LEVEL list screen appears.
6
Adjust the level by touching [ ] or [ ] of the
desired adjusting mode.
The level can be adjusted in the range of –5 to +5.
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1
Check that Defeat mode is off (page 25).
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [ ] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [ ] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [ ] or [ ] of USER PRESET to select any one
of the preset buttons (P-1 through P-6).
6
Touch [MEMORY].
The setting contents are stored.
• The stored contents will not be deleted even when the battery power
cord is detached.
Recalling the Preset Memory
1
Check that Defeat mode is off.
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [ ] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [ ] or [ ] of A.PROCESSOR to select the
preset memory you want to recall from P-1 through
P-6.
• It takes a few moment to recall the preset memory.
Using the Pro Logic II Mode
Pro Logic processing can be conducted on the music signals recorded
on two channels to achieve Dolby Pro Logic II surround sound. For
two-channel Dolby Digital and DTS signals, there is also a “REAR
FILL” function for outputting the signals of the front channel to the rear
channel.
1
Check that Defeat mode is off.
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [ ] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [ ] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [ ] of DOLBY PLII/REAR FILL.
The DOLBY PLII/REAR adjusting screen appears.
6
Touch [ ] or [ ] of DOLBY PLII/REAR to select the
desired mode.
PL II MOVIE: Suits the stereo TV shows and all programs
encoded in Dolby Surround. It improves the
sound field directivity to near that of discrete
5.1-channel sound.
PL II MUSIC: Can be used for all stereo music recordings, and
provides a wide, deep sound field.
OFF: Turns DOLBY PL II function to OFF.
01GB00IVAD100.book Page 46 Tuesday, February 14, 2006 4:10 PM