Kenwood C-BX3 - Manual (Page 8)

8
C-BX3
Getting started
(continued)
Connecting the DC power cord
1 Insert the DC power cord into the hole on the center of the
stand base.
2 Lace the DC power cord into the groove at the bottom of the
stand base. Then, stick the supplied adhesive tapes at the
recommended positions (as illustrated below) to hold the
power cord.
3 Align the DC power cord in between the side columns.
4 Connect the AC adapter to the DC IN jack on the rear of the
unit.
5 Plug the AC power cord (supplied) into a wall outlet.
¤ CAUTION
Make sure the DC power cord is firmly laced in the groove, otherwise, it •
may cause the stand to be unstable.
Disconnect the power cord before cleaning or moving the unit.
•
Do not place the AC adaptor in the column. •
To avoid the risk of fire and to prevent damage, •
Do not use any AC adaptors other than the one supplied. –
Do not use the supplied AC adaptor for other equipment. –
Rear of the unit
Wood pin
Wood pin
Side columns
Stand base
To a wall outlet
AC adaptor (supplied)
Basic operation
Turning on/off the power
Press .
⁄
A small amount of power is consumed even when the power is turned •
off (standby mode). During standby mode, the STANDBY indicator
lamp on the front panel lights up. Unplug the power cord from the AC
outlet to turn the power off completely.
You can also turn on the power by pressing one of the input buttons
•
(DIGITAL1, DIGITAL2, ANALOG, or iPod 6).
Activating/deactivating APS (Auto Power
Save)
The System automatically turns off to save the power.
Press and hold APS.
Each time you press and hold the button for 2 seconds, Auto Power Save
is toggled on or off (APS ON or APS OFF scrolls on the display).
The System automatically turns off to save the power when one of the •
following situations continues for 29 minutes:
For all sources:
When the volume is set to 0. –
When muting is activated. –
For DIGITAL 1/DIGITAL 2:
When the optical cord or coaxial cord is not connected, or there is –
no signal.
For iPod:
When iPod is not connected to the unit. –
Operations
Bottom of stand base
Adhesive tape
EN_C-BX3[E]f.indd 8 EN_C-BX3[E]f.indd 8 7/4/12 9:44:42 AM 7/4/12 9:44:42 AM