Fig. 3), In fig. 3), Fig. 3 – AMX Rough-In Box CB-TP15 User Manual
Page 2
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
4/11
©2011 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-032-10
REV: B
FIG. 2 Screw locations for Rough-In Box attachment in a pre-wall installation
FIG. 3 Wall Mount panel installation configuration for pre-existing Rough-In Box in a pre-wall construction
Drywall/
Stud
Knockouts should be located on the left-side of the
CB-TP15 Rough-In Box
Rough-In Box, alongside the connectors
Stud fastening holes
Use the four #4-40
Mounting Screws to
secure the NXD to the
Rough-In Box at these
sheetrock
Mounting tabs
for NXD panel should
be flush with the outside of the sheetrock
locations
B - Main NXD unit consists of
C - Optional CB-TP
Install the four #4-40
screws into the places
indicated
Stud
the touch panel and backbox housing
Rough-In Box
Cable
knockouts
Installed flush
against the
finished wall
Do not use these
tabs to mount
the rough-in /wallbox
These are ONLY used to
secure the main unit to the box
SURFACE
surface
A - Faceplate
(bezel)
Mounting Tab