Kenwood TK-3170E6 - Manual (Page 26)

19
CONVENTIONAL SCAN
If the Scan function is programmed, zones or channels can be
scanned by pressing the key programmed as Scan. Scan
can be used as either Single Scan or Multi Scan.
• Single Scan monitors only the channels of the currently selected
zone, which have been added to the scanning sequence. If set
up to scan the Priority channel, the Priority channel will be
scanned even if it is not within the currently selected zone.
• Multi Scan monitors all channels of every zone, which have been
added to the scanning sequence.
To activate Scan, press the key programmed as Scan.
• The icon and “ ” or the revert zone and channel number
appear.
• The zone add indicator ( ) will appear when the
selected zone is added to the scan sequence. The channel add
indicator (
) will appear when the selected channel is
added to the scan sequence.
• When a call is received, scanning stops and the zone and
channel digits appear. Press the PTT switch and speak into the
microphone to respond to the call. The transceiver will continue
scanning after a predetermined time delay if the PTT switch is
released and no further signal is received.
To stop scanning, press the Scan key again.
A
DD TO
S
CAN
/ D
ELETE FROM
S
CAN
Press the key programmed as Scan Delete/Add, to add or
remove each channel to or from the scan sequence.
• The channel add indicator ( ) will appear when the
selected channel is added to the scan sequence.
Press and hold the key programmed as Scan Delete/Add, to
add or remove each zone to or from the scan sequence.
• The zone add indicator ( ) will appear when the
selected zone is added to the scan sequence.