Kenwood TK-7185E - Manual (Page 20)

4
K
eypAd
e
nTry
Besides using the and keys, you can enter dialing codes manually, by
entering the numbers using the microphone keypad.
• Refer to the dialing codes listed in the appendix, starting on page 25.
■ r
ediAling
If a key has been programmed with Redial (default is the A key), you can
easily redial previously dialed call addresses.
Redial:
1 Press the key programmed as Redial.
2 Press the and keys to select  of the 3 last dialed numbers.
3 Press the Call key or the PTT switch to initiate the call.
e
mergency
c
AllS
If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
Note: Only the key can be programmed with the Emergency function.
Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver, the length of time you
must hold the Emergency key will vary.
p
ublic
A
ddreSS
(pA)
If your transceiver is connected to an external PA speaker, you can use the
transceiver as a Public Address system.
1 Press the key programmed as Public Address.
• The icon appears on the display while the PA system is active.
2 Press the microphone PTT switch, then speak into the microphone.
• Press the and keys ( Volume Up / Volume Down) to adjust the audio output
from the external speaker.
3 Press the Public Address key again to return to normal operation.
h
orn
A
lerT
If your transceiver is connected to your vehicle horn or other external device, this
function can alert you of an incoming call when you are away from your vehicle.
Toggle Horn Alert ON and OFF by pressing the key programmed as
Horn Alert.
• The icon appears on the display while Horn Alert is active.