Kenwood TK-2185E - Manual (Page 30)

20
k
eypAd
e
ntry
Besides using the selector, you can enter dialing codes
manually, by entering the numbers using the keypad.
• Refer to the dialing codes listed in the appendix, starting on page 6.
■
Redialing
If a key has been programmed with Redial, you can easily
redial previously dialed call addresses.
1 Press the key programmed as Redial.
2 Rotate the selector to select  of the  last dialed
numbers.
3 Press the Call key or the PTT switch to initiate the call.
e
mergency
c
AllS
If your transceiver has been programmed with the Emergency
function, you can make emergency calls.
Note: Only the Auxiliary (orange) key can be programmed with the
Emergency function.
Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver,
the length of time you must hold the Emergency key will vary.
A
uxiliAry
p
ort
If a key has been programmed with the AUX function, you can
press that key to turn the Auxiliary Port on and off.
• When the Auxiliary Port is activated, the AUX indicator
( ) appears on the display.
gpS r
eport
If a GPS unit (NMEA-08 format) is installed on your
transceiver and the Send the GPS Data function has been
programmed onto a key by your dealer, press the this key to
send your location data.