Kenwood K series - Manual (Page 4)

ENGLISH
4
System ..........................................3-Way 3-Speaker System
(Magnetically shielded)
Enclosure ....................................................Bass-Refl ex type
Loudspeakers
Woofer .......................... 120 mm (4-3/4 ") Cone type
Tweeter .......................... 25 mm (1 ") Soft Dome type
Super Tweeter ........ 20 mm (3/4 ") Hard Dome type
Nominal Impedance ........................................................6 Ω
Nominal Input Power .................................................... 40 W
Maximum Input Power ................................................. 80 W
Sensitivity ..................................................... 85 dB/W at 1 m
Frequency Response ....................................45 Hz ~ 40 kHz
Crossover Frequency ...................................... 3 kHz, 20 kHz
Dimensions ................................. Width : 180 mm (7-1/16 ")
Height : 330 mm (13 ")
Depth : 275 mm (10-13/16 ")
Net Weight .........................................5.7 kg (12.6 lb) / piece
Connections
Note on connection
• Never short the (+) and (–) speaker wire’s conductors to-
gether.
• Do not reverse L and R or (+) and (–) connections. Reversal
of sides or polarities may result in unnatural, incorrectly
positioned sound.
The speaker wire can also be connected to the speaker
by using banana plugs which are commercially available
in audio stores.
To use the banana plug connection, tighten the screws
on the speaker terminals before inserting the banana
plug.
Right Left
Wire with white line
1 Loosen 2 Insert the
conductor
3 Secure
Speaker terminals
(amplifi er or receiver)
Specifi cations
Note :
KENWOOD follows a policy of continuous advancements in
development. For this reason specifi cations may be changed
without notice.
Each speaker of this speaker system can be connected to
either the left or right output channel of the amplifi er.
CAUTION
Be sure to turn off your amplifi er before connecting or
disconnecting speakers.
Connections
Maintenance
1 2
Maintenance of the unit
When the speaker cabinets get dirty, wipe with the provided
cleaning cloth or with any soft, dry cloth.
Do not use thinner, benzine, alcohol, etc. for these agents
may cause discoloration.
In regard to contact cleaner
Do not use contact cleaners because it could cause a mal-
function. Be specially careful not to use contact cleaners con-
taining oil, for they may deform the plastic component.
B61-1299-00_0_LS-K1.indd 4 B61-1299-00_0_LS-K1.indd 4 06.9.26 11:00:20 AM 06.9.26 11:00:20 AM