APC AP9924 - Manual (Page 7)

Pre-installation Procedures
Wire Harness: Installation 5
Determine what connections you need to make:
1. If you are installing harnesses in one cabinet, connect the
following:
• one positive 1/2-fuse bus (+ 1/2) connector
• two positive 1/2-midpoint (+ 1/2) connectors
• one negative 1/2-fuse bus (- 1/2) connector
2. If you are installing harnesses in two cabinets, connect the
following:
Cabinet A:
• one positive 1/2-fuse bus (+ 1/2) connector
• two positive 1/2-midpoint (+ 1/2) connectors
Cabinet B:
• two negative 1/2-fuse bus (- 1/2) connectors
• one negative 1/2-midpoint (- 1/2) connector