Texsport 01250 The Lodge Tent - Manual

INSTRUCTIONS
Item 01250
The Lodge Square Dome Tent
Thank you for purchasing this Texsport tent. Please read and understand each step of the set-up instructions. We encourage you to set-up this tent
at least once prior to your camping trip, ensuring that you have a satisfactory understanding of the set-up process. We hope you enjoy your new
tent and that it will give you many years of camping pleasure.
Do not apply excessive force to this product.
PARTS LIST:
A ......Tent skin
B ......Rainfly
C ......2 Long end poles
D ......2 Short end poles
E ......2 Long pin tip poles
F ......2 Short pin tip poles
G ......2 Sets of tent poles
H ......2 Short middle poles
I ......2 Long middle poles
J ......Stakes, clews, and guy rope
NOTE:
Prepare your camp site by removing all sharp
stones, twigs, etc. The site should be flat and have
no depressions that could collect rain water.
A
B
C
D
E
F
G
H I
J
STEP 1 - Spread out tent skin. STEP 2 - Assemble the tent poles (G)
and insert through the tent sleeves. STEP 3 - Your poles should form an X
as shown above.
STEP 5 - Insert the pin and ring into the
tent poles on all 4 corners. STEP 4 - Use toggle on the top to se-
cure tent poles. STEP 6 - This is what your tent should
like.
DANGER: DO NOT RUN THE MOTOR OF THE VEHICLE THAT THIS TENT IS ATTACHED TO.
THIS CAN CAUSE SERIOUS INJURY OR DEATH FROM CARBON MONOXIDE POISONING.
TO AVOID SERIOUS BURNS OR DAMAGE TO THE TENT FABRIC WAIT AT LEAST ONE HOUR
FOR EXHAUST PIPE TO COOL BEFORE ATTACHING TO SUV.