Texsport 14444 Wok Package - Manual (Page 2)

Operating Manual
ITEM# 14444
Wok Package
1. Frame
2. Burner
3. Carbon Steel wok
4. CSA approved regulator
5. Thermometer
6. Two wooden utensils
CONTACT INFORMATION
If you should have any questions, problems or comments, please call
our Customer Service Department at 1-800-231-1402. This
Department is open 8AM – 5PM CST Mon-Fri. www.texsport.com
1
2
3
6
5
DANGER
KEEP THIS MANUAL FOR
FUTURE REFERENCE.
NEVER USE THIS
APPLIANCE IN AN ENCLOSED
SPACE SUCH AS CAMPER,
TENT, OR HOME.
USING IT IN AN ENCLOSED
SPACE CAN KILL YOU.
USE OUTDOORS
ONLY!
5
IMPORTANT
Read this manual carefully before assembling,
using or servicing this heater.
KEEP THIS MANUAL FOR FUTURE REFERENCE.
DANGER
CARBON MONOXIDE HAZARD
• This appliance can produce carbon monoxide which
has no odor.
• Using it in an enclosed space can kill you.
• Never use this appliance in an enclosed space such as
camper, tent, car or home.
! !
FOR YOUR SAFETY
IF YOU SMELL GAS:
• Do not attempt to light the appliance.
• Extinguish any open flame.
• Disconnect from fuel supply.
• If smell persists leave the area.
FOR YOUR SAFETY
NOTE: DO NOT STORE OR USE GASOLINE OR
OTHER LIQUID WITH FLAMMABLE VAPORS IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE .
WARNING
Misuse of this appliance can lead to fire, explosion
and serious personal injury to you or others.
Follow all instruction here, or on your
wok and on the bulk tank.
! !
4
CONNECTING THE BULK TANK
Step 1 ......Use only propane bulk tanks approved for use by the
United States Department of Transportation.
Step 2 ......Remove plastic protector cap from valve adapter connection
Step 3 ......Make sure that the regulator valve knob is turned off. Twist
in a clockwise direction.
Step 4 ......Be certain the POL adapter is undamaged rubber seal is
clean and undamaged.
Step 6 ......Screw POL adapter directly onto bulk tank fitting counter
clockwise. (hand tighten only)
Test the connection for leaking gas:
Step 7 ......Please check the connector for leaks using soapy water.
Apply soapy water to the connection area. Leaking gas will
produce bubbles. NEVER USE A FLAME.
Do you smell gas?
If yes, there is a leak.
Is the connection area extremely cold?
If so, there is a leak
DO NOT USE WOK IF IT IS LEAKING.
Step 8 ......When you are sure there are no leaks you may proceed to
lighting your wok.
LIGHTING YOUR HEATER
Step 1 ......Open the valve to a low or medium setting. Twist in a count-
er clockwise direction.
Step 2 ......Place a flame source near burner until it ignites.
Step 3 ......If heater fails to light, turn off the valve. Allow any gas to
dissipate and repeat steps 1-3.
Step 4 ......If w ok still does not light – contact Texsport Custom er
Service at 800-231-1402 8A M – 5PM CST M on-Fri.
14444 Instructions 12-10_Document 2 12/13/10 11:59 AM Page 2