Holtkoetter 2541 User Manual
Adjustable swing-arm floor lamp no. 2541, Assembly instructions for
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs not included. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Adjustable Swing-Arm Floor Lamp
No. 2541
Your floor lamp will come in two boxes, one for the shade and one for the base.
Assemble the Floor Lamp
1. Install the shade.
2. Unscrew the finished knob from the top of the lamp.
3. Remove the finished round disk from the lamp stem.
4. Place the shade over the center stem.
5. Put the finished round disk back on the stem.
6. Screw the finished knob back into place.
7. Install the bulbs of your choice (bulbs not included).
Maximum Wattage: 100 Watts, Medium Edison Base.
8. Your lamp is now operational.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used
to spot clean. Do not use common household cleaners on lamps or fixtures, as the
lacquer on the outside of the brass may be damaged as a result.