Holtkoetter 522 User Manual
Assembly instructions for
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Halogen Swing-Arm Wall Sconce
No. 522 & No. 523
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be
used to spot clean. Do not use common household cleaners on lamps or fixtures, as
the lacquer on the outside of the brass may be damaged as a result. Enjoy your new
Holtkötter lamp.
Please make sure that the following parts for your lamp are enclosed:
A. Bayonet Base Halogen Bulb
B. Glass Shield
C. Wall Sconce
IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN INSTALL THIS
FIXTURE.
General Installation Instructions
1. Remove the universal crossbar strap from the back of the sconce.
2. Connect the wires from the sconce with the wires in the outlet box according
to generally accepted electrical standards.
3. Mount the crossbar strap to the outlet box after making the wire connections.
4. Mount the backplate of the sconce to the crossbar strap and secure with
finished screws.
Bulb Installation
1. Unscrew the adjustment stem located on the shade, removing both the
small white washer and small plastic nut.
2. Put the halogen bulb into the socket. Holding the bulb at the porcelain grip,
push it down slightly and turn it clockwise.
BE CAREFUL NOT TO TOUCH THE BULB ENVELOPE WITH YOUR BARE HANDS.
3. Place the glass shield over the small screw extending from the bottom of the
socket. Place the small washer and the small plastic nut over the glass shield.
Now screw the handle back on, finger tight. DO NOT OVERTIGHTEN – THE
GLASS SHEILD MAY CRACK UNDER TOO MUCH PRESSURE.
Note of Caution: The recommended replacement bulbs for this fixture are 100 W
Osram Bayonet Base Halogen bulbs. Use of other brands of unknown quality may
cause a risk of overheating.
522/1
523/1