Holtkoetter 6238 - Manual

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Low-Voltage Desk Lamp
No. 6238
This low-voltage desk lamp
comes fully assembled. Included
with this lamp is one 35-Watt
Halostar IRC bulb by Osram. The
transformer, located in the base, is
manufactured by Lightech.
Replace the bulb
1. Remove the glass shield (B) by unscrewing the two phillips screws (C)
holding the glass shield in place.
2. Remove the bulb (A) by pulling it straight out of the socket.
3. Note: DURING INSTALLATION OF NEW BULB, BE CAREFUL NOT TO
TOUCH THE BULB ENVELOPE WITH YOUR BARE HANDS. Holding the bulb
envelope with a small cloth or tissue, push the bulb straight into the
socket.
4. Replace the glass shield, being careful to tighten the screws
gently against the glass shield. DO NOT OVERTIGHTEN.
Care Instructions
Use only a soft, dry cloth to clean. If necessary,
a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners
on lamps or fixtures, as the lacquer on the outside
of the brass may be damaged as a result. Enjoy
your new Holtkötter lamp.
CAUTION, IMPORTANT SAFETY INSTRUCTIONS
This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to
reduce the risk of electrical shock. This plug will fit a polarized outlet only one way. If the plug does
not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Never use with an extension cord unless plug can be fully inserted. Do not alter the plug.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC
SHOCK, EXPOSURE TO EXCESSIVE UV RADIATION OR
INJURY TO PERSONS
WARNING - To reduce the risk of FIRE, ELECTRIC SHOCK,
EXPOSURE TO EXCESSIVE UV RADIATION OR INJURY TO
PERSONS:
1. Turn off power/unplug and allow to cool before replacing bulb.
2. Bulb gets HOT quickly. Contact only switch/plug when turning on.
3. Do not touch hot lens, guard or enclosure.
4. Do not remain in light if skin feels warm.
5. Do not look directly at lighted lamp.
6. Keep lamp away from materials that burn.
7. Use only with a 35 Watt or smaller bulb.
8. Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb.
9. Do not operate the portable luminaire with a missing or damaged guard, lamp containment
barrier or UV filter.
SAVE THESE INSTRUCTIONS
C
B
A