Holtkoetter 6424LEDP1 - Manual

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Bernie Turbo Series LED Floor Lamp
No. 6424LED*P1
Congratulations, you have just purchased the leading-
edge dimming technology from Holtkötter International,
Inc. Our “Dimm-System Punkt 1” (Dimming System Point
1 (*P1)) is specifically designed to provide specialized
features for ease and convenience of use.
Features of “Dimm System Punkt 1” include:
Point Dimming - the lamp may be turned on
with a single click of the P1 dimmer.
Soft On - the lamp will come on low and continue to
brighten to full brightness. This allows the eye to adjust
to a gradual increase in light.
Soft / Delayed Off - turn the lamp off with a single
click of the P1 dimmer. The lamp will dim to 60%
brightness of the original setting, remaining briefly at
that level to allow you to exit the room; then the lamp
gradually turns itself off. This “soft” off provides a few
moments of light after turning the lamp off, rather
than immediate darkness as is the case with other
switches.
Dimming Cycle - to adjust the lamp to the perfect
light level for any situation, press and hold the P1
dimmer. The dimmer will cycle through all dimming levels. When the lamp
achieves the light level of your choice, release the P1 dimmer.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to
spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer
on the outside of the brass may be damaged as a result.
This low-voltage LED floor lamp comes fully assembled.
Technical Specifications
Light Engine: Holtkötter PC Board LED 11-8
with 8x CREE XP-G LEDs
Optic / Reflector: Holtkötter Aluminum Reflector
ø 134x100 with 60˚ x 5mm Optics
Light Output: 1120 Lumens equivalent to 80 W Halogen
Light Color: 2900 Kelvin
Control/LED Driver/Dimmer: Holtkötter Dimm-System LED Punkt 1 (*P1)
with full-range dimming of < 1% - 100%
Maximum Current/Voltage: 1000mA & 18V
System Power Consumption: 2 . . .12 Watt
6424/8*LED
Detail of LED Reflector