Holtkoetter 6424P1 - Manual

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Bernie Turbo Series Floor Lamp
No. 6424*P1
Congratulations, you have just purchased the leading-
edge dimming technology from Holtkötter International,
Inc. Our “Dimm-System Punkt 1” (Dimming System Point
1 (*P1)) is specifically designed to provide specialized
features for ease and convenience of use.
Features of “Dimm System Punkt 1” include:
Point Dimming - the lamp may be turned on
with a single click of the P1 dimmer.
Soft On - the lamp will come on low and continue to
brighten to full brightness. This allows the eye to adjust
to a gradual increase in light.
Soft / Delayed Off - turn the lamp off with a single
click of the P1 dimmer. The lamp will dim to 60%
brightness of the original setting, remaining briefly at
that level to allow you to exit the room; then the lamp
gradually turns itself off. This “soft” off provides a few
moments of light after turning the lamp off, rather
than immediate darkness as is the case with other
switches.
Dimming Cycle - to adjust the lamp to the perfect
light level for any situation, press and hold the P1
dimmer. The dimmer will cycle through all dimming levels. When the lamp
achieves the light level of your choice, release the P1 dimmer.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result.
UL requires the following safety instructions:
Lighted lamp is HOT! WARNING: Improper use of this fixture may increase the risk of FIRE,
ELECTRICAL SHOCK, EXPOSURE TO EXCESSIVE RADIATION or INJURY TO PERSONS.
IN ORDER TO REDUCE THESE RISKS, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS:
1. Before replacing bulb, UNPLUG lamp and allow bulb to cool.
2. DO NOT touch hot glass shield or operate lamp with a missing glass shield.
3. Keep lamp away from materials that may burn.
4. Do not remain in light if skin feels warm or look directly at a lighted bulb.
5. Use of the Osram bulb provided with this lamp prevents exposure to excessive UV Radiation.
Use of any other bulb may cause a risk of exposure to excessive UV Radiation. Use of any
other bulb may also cause a risk of overheating or may rupture the bulb.
6424/1*P1