Holtkoetter 8191 User Manual
Assembly instructions for
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Low-voltage Halogen Swing-Arm
Sconces No. 8191 & No. 8192
These low-voltage halogen wall sconces come fully assembled and ready for installation.
IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN
INSTALL THIS FIXTURE.
General Installation Instructions
1. Remove the universal crossbar strap from the back of the sconce.
2. Mount the universal crossbar strap to the outlet box before making the wire connections.
3. Connect the wires from the sconce with the wires in the outlet box according to generally
accepted electrical standards.
4. Mount the backplate of the sconce to the crossbarstrap and secure with finished screws.
Bulb Replacement Instructions
1. Be sure to turn the lamp off and allow it to cool before attempting glass shield and/or bulb
replacement.
2. The glass shield is held in place with an aluminum spring clip. To remove this clip, hold each
side and pull firmly from the socket. This will release the glass shield. (Skip to Step 5 unless
replacing bulb).
3. To remove the old bulb, pull it straight out of the socket.
4. Install the new bulb, being careful not to touch the bulb envelope with your bare
hands. Hold the bulb at the porcelain grip and push it straight into the socket.
Use only the Osram Halostar bulb, max. 50 Watts. Order Code: 9250*050-HSTAR
5. Press the aluminum clip over the shield and onto the socket, making sure that both sides
snap into place.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result.
max. extension: 28¼˝
5
5
⁄
8
˝
5
5
⁄
8
˝
max. extension: 49˝
5
5
⁄
8
˝
5
5
⁄
8
˝
8191/1
8192/1