Holtkoetter 5517 User Manual

Low-voltage halogen pendant no. 5517, Assembly instructions for

Advertising
background image

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

e-mail: [email protected]

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

®

and Holtkötter Leuchten

®

are registered trademarks of Holtkötter. All Rights Reserved.

© Holtkötter

Low-voltage Halogen Pendant

No. 5517

CSA/UL SAFETY REQUIREMENTS

CSA/UL requires that these IMPORTANT SAFETY INSTRUCTIONS be listed:

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY
LIGHTED LAMP IS HOT!
WARNING: TO REDUCE THE RISK OF FIRE OR INJURY, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS:

1. Turn off power and allow to cool before replacing lamps.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Keep lamp away from materials that may burn.
4. Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
5. Do not operate luminaire with missing or damaged glass.
6. CAUTION: The recommended replacement bulbs for this fixture are 20 Watt Halostar

bulbs by Osram. Use of other brands of unknown quality may cause a risk of
overheating.

Install the Bulbs & Glass (Diagram 4)

1. The bulbs provided with this fixture are specialty low-

voltage bulbs by Osram, the Halostar Starlite. Insert the
bulbs (M) into the sockets. NOTE: BE CAREFUL NOT TO
TOUCH THE BULB WITH YOUR BARE HANDS.

CAUTION: Always remember to disconnect power to
the fixture before replacing bulbs to prevent damage
to the bulbs.

2. Using the plastic socket driver (O) provided, screw each

glass shade (N) onto the fixture until it is snug. Do not
overtighten.

M

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.

5517/7

N

M

O

Diagram 4

Advertising