Holtkoetter 5583 User Manual
Assembly instructions for
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Holtkoetter Bath: Ludwig Series
No. 5583 & No. 5584
5584/4
1. Prepare to install the glass by seating the
plastic wrench inside the glass, aligning
the aluminum ring with the wrench.
2. Holding the wrench in place, set the
glass on the fixture over the bulb and
tighten the aluminum ring on the fixture
hand-tight.
3. The glass should fit snugly against the
fixture. See above.
4. Your wall sconce is now operational.
Bulb Replacement Instructions
1. Be sure to turn the lamp off and allow it to cool before attempting bulb replacement.
2. Remove the glass shade by unscrewing it with the plastic wrench.
3. Remove the old bulb by pulling it straight out of the socket.
4. Follow steps 1-4 under Bulb and Glass Installation Instructions.
Glass Shade Installation Instructions
5583/3