Burr King Model 1200 - Manual (Page 10)

• Remove the two screws that secure the aluminum cover plate on the right side
of the main casting. This plate bears the mark “Model 1200”.
• Loosen (do not remove) the two elastic nuts (use a 9/16 inch socket) inside
the main frame near the rear drive pulley. Exercise care not to nick or
otherwise damage the drive pulley. The pulley has a series of shallow
groves that drive the Micro-V flat drive belt. Any damage to the groves
will shorten belt life significantly.
• Pull the main frame forward in respect to the motor. The frame will slide
across the motor face with the above elastic nuts loose.
• The belt is properly tensioned when a force of approximately 5 pounds will
deflect the belt approximately ¼ inch near the center of the belt track.
• Tighten the two elastic nuts securely and reinstall the cover plate.
Vacuum or otherwise remove dust and debris build-up regularly from the machine,
There are no other maintenance actions required. All bearings are sealed for life and
require no lubrication.
-----------------------------------------------------------------------------------------------------------
-
Remember for operator safety and the continued effectiveness of your Model 1200:
Do not defeat the safety guards and other safety provisions of the Model 1200.
Do not reach inside the safety guards while the machine is running. To do so is
hazardous.
Do not use fluids in your buffing process unless your Model 1200 is designed for
liquid operation (NEMA 4, 4X). To do so may create an electrical safety hazard.
Do not use your Model 1200 to polish explosive materials unless it is equipped with
explosion proof electrical devices and motor.
Do not mix alloys in your buffing. To do so may create an explosion hazard.
Do not use stone or vitreous wheels on the Model 1200. To do so will create an
operator safety hazard.
Do use eye, hand, face, arm, leg, feet and body protection that is adequate to protect
against flying debris, forcibly ejected work pieces, etc.
Do not wear loose fitting, of hanging clothing that might become entangled in the
rotating wheels, or shafts.
Do train operators and others in safe operating practices.
Post these or equivalent instructions such they are available for ready operator
reference.
For spare parts, or other assistance contact your Burr King distributor; or, contact Burr
King Manufacturing at 1-660-438-8998
4