Microlab FC 360 5.1 - Manual (Page 3)

15. Attachments - Do not use attachments not recommended by the product manufactures, as they
may cause hazards.
16. Accessories - Do not place this product on an unstable cart, stand, tripod, bracket or table. The
product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only
with a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the product. Any
mounting of the product should follow the manufacturer's instructions and should use a mounting
accessory recommended by the manufacturer.
17. Moving the product - A product and cart combination should be moved with care. Quick stops,
excessive force and uneven surfaces may cause the product and cart combination to overturn.
18. Unused periods - The power cord of the appliance should be unplugged from the outlet during
lightning storms or when the apparatus is left unused for a long period of time.
19. Servicing - Do not attempt to service this product yourself, as opening or removing covers may
expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
20. Please remove the power plug form the main power source or wall power source when not in use.
When plugged in to a power source, the system is in standby mode, so the power is not entirely cut off.
21. Replacement parts - When replacement parts are required, ensure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock or other hazards.
22. Mains fuses - For continued protection against fire hazard, use fuses only of the correct type and
rating. The correct fuse specification for each voltage range is marked on the product.
23. Do not turn up the volume while listening to a section with very low level inputs or no audio signals. If
you do, the speaker may be damaged when a peak level section is suddenly played.
24. The only means of completely disconnecting the product from the power supply is by removing the
power cord from the wall outlet or the product. The wall outlet or the power cord entry to the product must
remain freely accessible at all times while the product is in use.
25. Try to install the product near a wall socket or extension cord and shall be easily accessible.
26. The highest environmental temperature suitable for this product is 40°C.
EN
3
Introduction
Features
Packing list
You should find following items while unpacking:
Illustrations
Product connection and operation
Connections
1. Connect the front satellites to the left and right RCA sockets.
2. Next connect the rear satellites to the surround left and right RCA sockets.
3. Connect the subwoofer to the SW input jack.
4. Place both front satellites on extreme sides and forward of the listening position. Place both surround satellites on the
extreme sides and rear of the listening position.
5. Last place the subwoofer on the floor with its back close to a wall. Subwoofer produces low frequency sound thus it can
be placed in any position relative to the listener.
6. Connect the playback device to the rear input RCA sockets of the amplifier with the included cables, or to the front 3.5mm
stereo input jack.
7. The amplifier should be placed near a power source and near the playback device such as CD/DVD, Mp3/Mp4 player or
TV.
8. Last, connect the AC power cable at the rear of the amplifier to the AC power supply source. Please ensure the AC power
supply match the power requirement printed at the rear panel.
Operation
1. Ensure the master volume is at the lowest setting.
2. Turn on the main AC power and switch on the speaker system from the top power switch.
3. Start the playback device and song
4. Slowly adjust the volume to your preferred volume level and enjoy.
Note: it is advisable not to turn the volume too loud or to its extreme volume limit to avoid damage to the speaker driver
material. Always adjust in slow increment.
4. Slowly adjust the master volume to your preferred volume level and enjoy. This can be adjusted with the main master
volume on the amplifier or remote control.
5. This system features 2 input types: stereo and 5.1 channels, and 2 output types; 2.1 and 5.1 channels. These options are
available in the remote control. Create your own sound effects with these options according to the movie effects and room.
6. For sound effects option: the remote control features subwoofer bass level, and surround rear speakers level controls.
7. Left and right balance controls on the remote control allows you to fine adjust the optimum listening position
8. The Mute button on the remote control lets you interrupt the playback output on the entire speaker system.
9. The Standby button lets you put the speaker system on hold in between song playbacks. This is an energy savings
feature that lets you save electricity power.
Note: it is advisable not to turn the volume too loud or to its extreme volume limit to avoid damage to the speaker driver
material. Always adjust in slow increment. Do not block the ventilation of the amplifier during use.
EN
4
FC360 subwoofer 1pc
FC360 satellites 5 pcs
FC360 amplifier 1pc
2RCA-2RCA cable 3 pcs
Front view
1. Power LED
2. Input LED: 5.1 and 2.0 channels
3. Master volume knob
4. Power button
5. Mute LED
6. Volume LED
7. Output LED: 2.1 and 5.1 channels
8. Input selector: select between 2.0
and 5.1
Front View Remote control
High Fidelity 2.1 speaker system with the excellent FineCone drivers
Microlab premier range, the FC series is based on the FINE CONE designed by acoustic
expert, Peter Larsen that attains perfect linear frequency response curve. This
characteristics offers distortion free and uncoloured sound. Perfect sound everytime from
your music playbacks and for your perfect entertainment.
Uncolored audio, precise position, and high resolution with Microlab own eAirbass
technology
1. High Fidelity 2.1 subwoofer speaker system with crystal clear acoustics and rich sound
2. 6.5" woofer and 2.5" x 2 V16 full range speakers with perfect linear frequency response curve,
designed by Danish acoustic master, Peter Larsen.
3. Superb dynamics, depth and deep bass - ideal for all audio type of playbacks
4. Slim satellites with tight and clear acoustics
5. Standalone amplifier unit for distortion free and interference free audio, with front controls for easy
access
Back view
Remote control
1. Stand by
2. Input select: 2.0/5.1 channels
3. Surround fine adjustment
4. Master volume control
5. Mute
6. Output mode: 2.1/5.1 channels
7. Bass fine adjustment
8. Center fine adjustment
9. balance adjustment Back view
1. 5.1 input:
front jacks
center jack
rear jacks
2. Front jacks: to front satellites
3. AC cord: to AC power supply
4. Stereoinput: from stereo playback
sources such as CD/DVD, Mp3/Mp4
players
5. 5.1 input: bass jack
6. Bass jack: to subwoofer
7. Rear jacks: to rear satellites
8. Center jack: to center satellite
9. Fuse: T800AL250V
AC IN FUSE
T800mAL250V
AUDIO OUTPUT FRONT BASS REAR
CENTER
R
L
R
L
AUX INPUT
5 . 1 INPUT
L
MULTIMEDIA SPEAKER
MADE IN CHINA
MODEL : FC360 / 5 . 1 AC IN : 220 V - 240V ~ 50Hz 380m A
+ -
ST-BY MUTE
INPUT SEL MODE
SURR+ CENTER+ SUB-W+
SURR- CENTER- SUB-W-
VOLUME+ BALANCE R
VOLUME- BALANCE L
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
3.5mm stereo - 2RCA cable 1pc
Remote control 1 pc
User manual 1pc