AMICA ZZM616W EN User Manual
Page 18
It is dangerous to open the door when washing,because the hot water may scald you.
Switch Off the Dishwasher
The program light isn"t blinking and is lignt, only in this case the programme
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
has ended.
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes.
In this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and than the upper one. This will avoid water dripping from the
upper basket onto the dishes in the lower one.
16
The filter prevent larger remnants of food or other objects from getting inside the pump. This residue can
occasionally clog up the filters.
The filter system consists of a coarse filter,a flat (Main filter)
And a microfilter(Fine filter).
Main filter
Food and soil particles trapped by this filter are pulverized by a
special jet on the lower spray arm and washed down the
drain.
Coarse filter
Larger items, such as pieces of bone or glass, that could clog
the drain are trapped in the coarse filter. To remove an item
caught in this filter, gently squeeze the taps on the top of this
filter and lift it out.
Fine filter
This filter holds soil and food residue in the sump area and
prevents it from being redeposit on the dishes during a cycle.
2
3
1
2
3
1
- Inspect the filters for obstructions every time the dishwasher has been used.
- By unscrewing the coarse filter.you can remove the filter system.Remove any food remnants and clean the
filters under running water.
1
2
step１：contrarotate the C
,
and then lift it up;
oarse filter
step２：lift the Main filter up
As the pictures show,you can remove the filter system step by step, Following the opposite steps you can install
the filter system again.
NOTE：
3
step 3： lift the Fine filter up