Altinex V-MATRIX VM2128ME - Manual (Page 7)

V-MATRIX
6
6
INSTALLING YOUR VM2128ME 5
Step 1. Attach the VM2128ME to the enclosure
using the lock-down screws to secure it
into place.
Step 2. Connect the power entry connector of the
enclosure to the power outlet with the
power cord. The power supply will work
with voltages between 90V-265V.
Step 3. Once the power is connected, power
LED's on the front panel will turn red
indicating that the unit is on. Green status
LED's indicate that the system is
operating properly. If the status LED is
blinking red, the unit is experiencing a
problem.
Step 4. To remove the VM2128ME from the
enclosure, unfasten the lock-down screws
and pull on the inside handles.
OPERATION 6
The VM2128ME Matrix Engine will operate
successfully as long as the unit is installed properly
and other technical specifications are followed.
TROUBLESHOOTING GUIDE 7
We have carefully tested and have found no
problems in the supplied VM2128ME; however, we
would like to offer suggestions for the following
:
•
First, make sure that power is connected to the
power-input connector and input power is within
the range of 90-265 VAC.
•
Make sure that the chassis is turned off before
installation.
•
Make sure that the VM2128ME is properly
attached to the enclosure.
•
If the LED's are not lit, make sure that there is
powered connected to the unit.
•
Make sure that the cards being used are
pushed in all the way into the enclosure.
•
If there is problem with the unit please call
ALTINEX at (714) 990-2300.