AMICA FD228.3AA - Manual (Page 65)

65
TROUBLE-SHOOTING
Problems Possible causes Remedies
The appliance
does not work
The electric circuit is disrupted
- check whether the plug is properly inserted into
the socket
- check whether the power cable of the appliance
is not damaged
- check whether there is voltage in the socket, by
plugging another appliance, e.g. a night lamp
- check whether the appliance is switched on by
setting the thermostat to a position above 0.
The lighting inside
the chamber does
not work
The bulb is loose or fused (only applian-
ces with bulb lightning type)
- fit the bulb correctly or replace it (see section above
“Replacing the interior light bulb)
Temperature insi-
de the appliance
is not low enough
or too high
Incorrect setting of the adjustment knob - reset the knob to a higher position
The ambient temperature is higher or
lower than the climate range from table
with technical specification
- the appliance is adapted to operation in the cli-
mate range from table with technical specification.
The appliance is located in a sunlit place
or near heat sources
- move the appliance to another place. Observe
the guidelines contained in the manual
Too much warm food loaded at a time
- wait 72 hours until the food becomes cool (fre-
ezes) and the required temperature is reached
inside the chamber
Internal air circulation obstructed
- place the food and containers in such a way that
they do not touch the rear wall of the fridge
The air circulation at the back of the
appliance is obstructed
- move the appliance min. 30 mm away from the
wall
The door of the frid- ge/freezer is opened
too often and/or remains open for too
long
- reduce the frequency of opening the door and/or
shorten the time when door remains open
The door does not close completely
- place the food and containers so that they would
not interfere with door closed
The compressor is switched on too rarely
- check whether the ambient temperature is not
lower than climate class
Door gasket inserted incorrectly - press the gasket in
The appliance
works continu-
ously
Incorrect setting of the adjustment knob - reset the knob to a lower position
See. ”Temperature inside the appliance
is not low enough for description of other
possible causes
See. ”Temperature inside the appliance is not low
enough for description of other possible remedies
Water collects in
the lower part of
the appliance
The water discharge opening is clogged
(depending on the model)
- clean the discharge opening (see the operating
manual – chapter entitled ”Defrosting the fridge”)
Internal air circulation obstructed
- place the food and containers in such a way as
that they do not touch the rear wall of the fridge
The appliance
generates unusual
noise
Incorrect levelling of the appliance - level the appliance properly
The appliance is touching furniture and/or
other objects
- place the appliance at a location that ensures
proper clearances around it
Certain sounds can be heard during normal use of the refrigerator, which do not affect its correct operation.
Sounds, which can be easily prevented:
l noise caused by the appliance which is not level - adjust the position with the adjustable turn-in front feet. Alterna-
tively, place pads made of soft material under the rear rollers, especially when the appliance is placed on tiles.
l touching the adjacent piece of furniture - move the refrigerator away.
l creaking of the drawers or shelves - take out and put back the drawer or shelf.
l sounds of clinking bottles - move bottles apart.
Sounds heard during normal use are mainly due to operation of the thermostat, compressor (switching on) and cooling
system (thermal expansion and contraction of the radiator caused by flow of the cooling agent).
EN