MagTek MINI MICR RS232 User Manual
Mini micr rs232, With optional 3-track msr
Advertising
Table of contents
Document Outline
- SECTION 1. OVERVIEW
- SECTION 2. INSTALLATION
- SECTION 3. OPERATION
- SECTION 4. COMMANDS
- INSTA-CHANGE CHECKS
- MICRBASE SETUP PROGRAM FOR WINDOWS
- MAGTEK DEVICE DRIVERS FOR WINDOWS
- COMMAND FORMAT
- SWA - SWITCH A COMMAND
- SWA PARAMETERS
- SWB - SWITCH B COMMAND
- SWB PARAMETERS
- SWC - SWITCH C COMMAND
- SWC PARAMETERS
- HW - HARDWARE COMMAND
- HW PARAMETERS
- FC - FORMAT CHANGE COMMAND
- VR - VERSION COMMAND
- SA - SAVE COMMAND
- RS - RESET COMMAND
- DM – DISABLE MICR COMMAND
- EM – ENABLE MICR COMMAND
- APPENDIX A. FORMAT LIST
- APPENDIX B. CHECK READING
- APPENDIX C. TROUBLESHOOTING GUIDE
- REQUIREMENTS
- SET-UP
- 00 CHECK LED
- 01 CHECK THE POWER TO THE MICR READER
- 02 READ A CHECK
- 03 DID PC RECEIVE DATA?
- 04 ANALYZE DATA
- 05 VERIFY PARAMETERS
- 06 READ ERROR
- 07 MISSING CHARACTERS
- 08 COMMUNICATION PARAMETERS DO NOT MATCH
- 09 INCORRECT FORMAT
- 10 PATH IS OBSTRUCTED
- 11 MOTOR SENSOR IS BLOCKED
- 12 EMF NOISE/INTERFERENCE
- 13 DATA SENSOR IS BLOCKED
- 14 NO MICR DATA DETECTED
- 15 CABLE PROBLEM
- 16 NO PROBLEM FOUND
- 17 READ INSTA-CHANGE CHECK
- 18 RETURN MICR READER TO MAGTEK
- APPENDIX D. INTERFACE CABLE PIN LISTS
- APPENDIX E. ASCII CODES