Midco F400-33 - Manual

WARNING: If the information in these
instructions is not followed exactly, a fire
or explosion may result, causing property
damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch;
do not use any phone in the building.
Immediately phone your gas supplier from
another building. Follow the gas supplierÕs
instructions.
If you cannot reach your gas supplier call
the fire department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
BURNER
MODEL
BILL OF MATÕL
NUMBER
DATE
CODE
WIRING
DIAGRAM
FOR SERVICE CONTACT:
name
address
phone
SAFETY INFORMATION TERMS. The following terms are used to identify hazards, safety precautions or special notations
and have standard meanings throughout this manual. They are printed in all capital letters using a bold typeface as shown below,
and preceded by the exclamation mark symbol:
DANGER: Identifies the most serious hazards which will result in severe personal injury or death.
WARNING: Signifies hazards that could result in personal injury or death.
CAUTION: Identifies unsafe practices which would result in minor personal injury or product and property damage.
ECONOMITE MODELS
400-33 AND F400-33
Gas Conversion Burners
In the United States, Installation must conform with local codes
or, in the absence of local codes, with Installation of the
National Fuel Gas Code, ANSI Z223.1-1992, or latest edition
available from American National Standard Institute. Further
reference should be made to the recommendation of your
fuel supplier.
In Canada, Installation must conform with local codes or, in the
absence of local codes, with Installation Codes for Gas
Burning Appliances and Equipment, CGA Standard
CAN/CGA 1B-149.1 or 2. When the conversion burner is used
on a Forced Air Central Furnace, the two yellow and black
warning labels in the literature envelope shall be attached in
accordance with Installation Code, CGA Standard CAN/CGA
1-B149, Clause 5.4.4.4. Further reference should be made to
the recommendation of your fuel suppler.
WARNING: Additions, changes, conversions, and service
must be performed by an authorized MIDCO representative,
service agency, or the fuel supplier. Use only MIDCO
specified and approved parts.
INSTALLER: Inform and demonstrate to the
user the correct operation and
maintenance
of the gas utilization
equipment. Inform the user of the
hazards of storing flammable liquids and
vapors in the vicinity of this gas utilization
equipment and remove such hazards. Affix
this manual and associated literature
adjacent to the conversion burner.
CODE COMPLIANCE IS THE SOLE
RESPONSIBILITY OF THE INSTALLER.
USER: Retain this manual for future reference.
If other than routine service or
maintenance as described in this manual and
associated literature is required,
contact
a qualified service agency. DO NOT ATTEMPT
REPAIRS. An inadvertent service error could
result in a dangerous condition.
INSTALLATION AND
SERVICE INSTRUCTIONS
PRINTED IN U.S.A.
797
8449-84
¥
¥
¥
¥
¥
MIDCO International Inc.
4140 WEST VICTORIA STREET ¥ CHICAGO, ILLINOIS 60646 ¥ (773) 604-8700 FAX: (773) 604-4070 ¥ http://www.midco-intl.com