On the Edge Marketing Folding Wheelbarrow - Manual

Folding WheelbarroW assembly instructions
Step 1: Feed the Left/Right Handle
down the correct sleeve on the wheel
barrow fabric.
Step 4: Remove the nut holding
the wheel axel in place and remove
the axel about 1/2 from the Wheel
Bracket. There should only be one
(1) wheel spacer still on the axel.
Step 2: Once the Handle is fed all
the way through the sleeve remove
the nut and bolt at the bottom of the
sleeve to allow the Handle to be
secured to the Wheel Bracket.
Step 5: Place the Wheel between
the wheel axel and the Wheel
Bracket. Insert the wheel axel
through the wheel center and
the second wheel space before
inserting the axel through the hole
on the Wheel Baracket. Hand
tighten the nut and bolt to hold the
wheel in place.
Step 3: Slide the Handle all the way
down the sleeve and align hole on the
Handle with the holes on the Wheel
Bracket. Insert the bolt you removed
in Step 2 throught the holes in the
handle and Wheel Bracket paying close
attention that the Protective Sleeve
(insert) is still on the handle and habd
tighten the nut to the bolt. Repeat for the
other handle.
Step 6: Using an open end wrench
or socket wrench tighten down all
the nuts while appyling preasure
to the head of the bolt making sure
the tab on the bolt is in the notch on
the frame so that the bolt sits flush
frames surface. This will ensure a
secure tightening and prevent the
bolt from turning.
1 Right Handle (1)
2 Left Handle (1)
3 Wheel Bracket with
Attached Fabric (8)
4 Wheel (1)
Parts List Technical Notice
2
3
4
1
rev. 05-2009
For replacement parts or missing pieces, please do not return this product to the retailer. Call 949.305.4830 for replacement parts.
The bolts you will be using
to assemble this products
have tabs under the head
of the bolt that fit into the
holes on the Wheel Bracket
to keep the bolt from
rotating while tightening
the nut down securley.
Pay close attention when
tightening down the nut.