Princeton Tec SWITCH RAIL - Manual (Page 2)

Operating And Maintenance Instructions
Battery Installation
See Battery Installation Diagram
•(2) 2016 coin cells
WARNING
Remove batteries during long periods of
storage. Remove exhausted batteries
from light immediately.
Switch Operation
A single press of the button turns on the
primary LED in low output mode.
A double press of the button turns on
the primary LED in high output mode.
Holding the button causes the secondary
LED to turn on. The secondary LED has
one output level. Continued holding
switches back to the primary LED.
Any button press after 2 seconds turns
the light off.
Troubleshooting
If the Switch Rail fails to light:
• Check the batteries for proper
installation.
• Replace batteries if proper installation
is confirmed.
• Check the light for water
contamination. The light will resume
normal operation once the water is
shaken or blown out and the light is left
open until completely dry. If the light
has been contaminated with salt water,
flush the unit with fresh water and dry
as described above.
USA– International 1-Year Warranty
WARRANTY – Princeton Tec warrants this
product to be free from defects in
workmanship and materials under
normal use for as long as you own this
product. This warranty covers all of the
component parts of the product except
batteries. This warranty does not cover
deterioration due to normal wear or
damage due to misuse, alteration,
negligence, accidents, or unauthorized
repair. Princeton Tec will repair or
replace parts which are defective in
workmanship or materials.
Your authorized Princeton Tec Dealer
and Princeton Tec are the only facilities
authorized to repair the product. After
(3) unsuccessful attempts (within the
warranty period) to repair the product,
you have the right to elect replacement
of the product or a refund of the
purchase price less allowance for use of
the product. NO INCIDENTAL OR
CONSEQUENTIAL DAMAGES ARE
INCLUDED IN THIS WARRANTY. (Some
states do not allow the exclusion or
limitation of incidental or consequential
damages, so the above limitations or
exclusions may not apply to you.) This
warranty gives you specific legal rights,
and you may also have other rights
which vary from state to state.
Princeton Tec reserves the right to
change product specifications
without notice.
Return Policy
If your light fails to operate, follow these
simple steps:
1) Check battery. Replace if necessary.
2) Contact Princeton Tec customer
service at 800-257-9080 to request RMA
number. No warranty repairs accepted
without RMA number.
3) Return the light without batteries for
repair or replacement to: Princeton Tec,
5198 Rt. 130, Bordentown, NJ 08505.
Postage due and freight collect items
will not be accepted.
Princeton Tec
PO Box 8057, Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2013 Princeton Tec