Clary CMN2000IPA - Manual (Page 18)

Page 18
⇒ The AC OUTPUT L.E.D. will illuminate indicating output power is available at the rear panel
outlets.
The ALARM RESET Switch on the front panel of the UPS or the Control Panel can be used at
any time to silence the audible alarm. This switch must be held in for at least two seconds before
the alarm will quiet. The FAULT L.E.D. above this switch will remain unchanged while operating
this switch.
ALLOW AT LEAST 24 HOURS, AFTER THE SYSTEM IS FIRST INSTALLED, TO FULLY
CHARGE THE BATTERIES TO A MAXIMUM STATE.