Legacy Classic Furniture Desk Chair - Manual

Assembly Instructions For Chairs
CAUTION: TO PREVENT SOILING OR DAMAGE TO FLOORS OR CARPETS, PLEASE CHECK THE BOTTOM OF EACH PIECE OF FURNITURE FOR STAIN RESIDUE AND
ROUGH SURFACES AND ALSO CHECK FOR STAPLES OR NAILS LEFT AFTER REMOVING THE PACKAGING MATERIAL. WIPE OFF ANY EXCESS STAIN RESIDUE WITH
A CLOTH RAG REFORE ASSEMBLY AND PLACE MENT OF THE FURNITURE ON FLOORS OR CARPETS. THE MANUFACTURER WILL NOT BE HELD RESPONSIBLE IF
PREVENTATIVE STEPS ARE NOT TAKEN PRIOR TO INSTALLATION.
Important note:
1.Use only the hardware supplied.
2.Do not over-tighten bolts
3.First read the chair leveling instruction sheet.
Assembly Instructions:
STEPS
1. PLACE THE UPHOLSTERED SEAT CUSHION( A ) UPSIDE DOWN ON A CLEAN, SOFT SURFACE.
2. ASSEMBLE THE BACK FRAME ( B ) TO THE BACK RAIL OF THE SEAT FRAME ( A ) USING ----- # 1 ( BOLT + SPRING WASHER + FLAT WASHER ).
3.
ATTACH THE REAR CORNER BLOCKS OF THE SEAT FRAME ( A ) TO THE BACK LEGS AND FRAME ( B ) USING ----- # 2 ( BOLT+ SPRING
WASHER + FLAT WASHER ).
4. ASSEMBLE FRONT CORNER BLOCKS OF SEAT FRAME WITH THE FRONT LEGS ( C ) USING ----- # 3 ( BOLT + SPRING WASHER + FLAT
WASHER ). HAND TIGHTEN THESE BOLTS WITH WRENCH # 4.
5. AFTER MAKING SURE ALL BOLTS ARE ATTACHED AND HAND TIGHTENED, TURN THE CHAIR OVER.
6 . LEVEL THE CHAIR FOLLOWING “CHAIR LEVELING INSTRUCTION” .
7. MAKE SURE THE CHAIR IS LEVEL AND THEN TIGHTEN ALL BOLTS COMPLETELY USING THE WRENCH SUPPLIED.
8. REMOVE THE PLASTIC COVER ON THE UPHOLSTERED SEAT ( A ).
PART LIST QTY NO. HARDWARE LIST QTY
A
UPHOLSTERY SEAT
CUSHION WITH
WOOD FRAME
1PC # 1 1-1/2’’ L
BOLT + SPRING WASHER + FLAT
WASHER ----- 5/16” Dia
2SETS
B CHAIR BACK FRAME 1PC # 2 3’’ L
BOLT + SPRING WASHER + FLAT
WASHER ----- 5/16” Dia
4SETS
C FRONT LEG 2PCS
# 3 2-1/2’’ L
BOLT + SPRING WASHER + FLAT
WASHER ----- 5/16” Dia
4SETS
# 4 WRENCH 1PC
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE PERIODICALLY INSPECTED
AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK TO BE SURE THAT ALL HARDWARE IS KEPT TIGHTENED.